Dishwasher

Kitchen Appliances

Power Cord Replacement (part #4317824) - Whirlpool Dishwasher Repair

Connect Direct Wire Electrical to Dishwasher

Kitchen Appliances

Installing A New Dishwasher 

House electrical circuit layout

How to Properly Install Your LG Dishwasher

Dishwasher Repair - How It Works

Go Pro - Full wash cycle in a dishwasher

Dishwasher Drain Hose - How to Install Dishwasher Drain Hose

• Install a romex clamp in the 3/4 inch hole in the electrical junction box in the bottom front of the dishwasher.


• Run the cord through the clamp and leave several inches of cable in the box.NOTE: For this dishwasher installation, I prefer to strip the electrical cord before placing in the box. I strip off 3 inches of insulation revealing the three wires (black, white and green). I then strip off 3/4 inch of insulation on each wire and tightly twist the end.


• Tighten the screws on the clamp just enough to provide strain relief. Do not damage the electrical cord.


• Join the electrical cord to the wires from the dishwasher using the yellow wire nuts. Some manufacturers simply connect the green wire to a screw on the chassis.


• After all the connections are completed, place the cover over the wiring. Usually it will hinge in with just 1 screw.


• Turn on the water and check for leaks.


• Plug in the electrical cord, no sparks or smoke? Good.NOTE: If you open the door, hold onto the door as the brackets that keep the dishwasher from tipping forward are not yet attached.


• Turn on the dishwasher. Does it run OK with no leaks?

240 Volt Circulation Pump With 240 Volt Chlorine Generator

Dishwasher air gap

Dishwasher Pump Wiring

dishwasher stand pipe

homebase how to install a dishwasher or washing machine

Power Cord Assembly for Disposer

Replacing a Dishwasher